The Contessa 28 offers an excellent blend of confidence inspiring sailing performance and useful accommodation, offering up to five berths. Less well known than earlier Contessa yachts, the 28 was more modern with an improved interior and moulded headlining, often considered an earlier rival to the Sadler 29. 'Midnight Lady' is a good example of her class fitted with a 2006 Nanni 21hp diesel engine and a recent chart plotter and windlass. She is competitively priced as a recent survey identified that the decks will require attention in the future.

Viewing by appointment only through our Essex office (01621) 785600 or email: essex@clarkeandcarter.co.uk

Accommodation

The Contessa 28 layout offers six berths in one cabins with approximately 6'1" headroom. Forepeak with double vee berth, stowage and opening hatch to foredeck. Moulded heads compartment to starboard with a Lavac marine toilet, wash basin with cold water supply, storage and a hanging locker opposite. Saloon comprising of a settee berth to port with trotter box, folding central table and a further settee berth to starboard which converts into a double berth. Sliding chart table aft to starboard with quarter berth beneath. Galley to port consisting of a Bainbridge Plastimo stainless steel two-burner gas cooker with oven and grill, sink with cold water supply and stowage areas. Shaped blue upholstery throughout with complimenting curtains and moulded headlinings.

Mechanical Systems

Located under companionway, Nanni 3.75HE, three-cylinder, 21hp marine diesel engine (2006). Fresh water cooled. Single lever engine controls with electric start. 40 litre stainless steel fuel tank. Shaft drive to fixed three bladed propeller. In 2014 a new cutlass bearing, shaft seal and propeller were installed.

Electrical Systems

2 x 12v batteries (2011) charged via the engine alternator. Shorepower system with ring mains. Full cabin lighting.

Spars and Sails

Masthead Bermudan sloop rig. Silver anodised aluminium mast and boom (2001) by Kemp. Stainless steel standing rigging with adjustable backstay. Terylene running rigging (new 2013) led aft to the cockpit via Barton jammers and with backstay tensioner. Single line slab reefing to mainsail. Furlex headsail furling system (2001). 2 x Lewmar 40 self-tailing sheet winches (2013). 3 x Halyard winches.

Deck Equipment

Navigation Equipment

Safety Equipment

Construction

Contessa 28 built by Jeremy Rogers in 1978 to a Doug Peterson design. White GRP hull (epoxy coated in 2003) with style stripes, coachroof and grey moulded non-slip decks. Encapsulated lead ballast in fin keel. Tiller steering to semi-balanced rudder. Self-draining cockpit. Simulated teak finish to cockpit seats. In 2015 the rudder was removed, faired and epoxy coated before being refitted and the aluminium windows were also replaced. A recent survey has identified that moisture has entered areas of the deck, and whilst it is still possible to use without repair, it would be advisable to rectify this in the future. In July 2022, all seacocks were replaced.

Disclaimer

The company normally acts as brokers for the vendor who unless otherwise stated is not selling in the course of a business. Whilst every care has been taken in the preparation of these particulars the correctness is not guaranteed and they are intended as a guide only and do not constitute a part of any contract. A prospective buyer is strongly advised to check these particulars and where appropriate and at his own expense to employ a qualified marine surveyor to carry out a survey and/or to have an engine trial conducted which if conducted by us shall not imply any liability on our part.

General note on safety equipment: Any safety equipment such as liferaft, fire extinguishers and flares etc., are usually personal to the current owner(s) and if being left on board as part of the sale of a used vessel, may require routine servicing, replacement, or changing to meet the specific needs of the new owner(s).